Engorio.in
Home › Projects › Electrical › TauStrike — RC Time Constant Trainer

TauStrike — RC Time Constant Trainer

Electrical Beginner Arduino Uno Arduino C++
TauStrike — RC Time Constant Trainer project banner

About this project

TauStrike is a hands-on RC circuit trainer that measures the time constant (τ = RC) experimentally. Arduino Uno times a 100 µF electrolytic capacitor charging through a 10 kΩ resistor until the voltage crosses the critical 63.2 % of Vcc threshold — exactly one time constant. A TM1637 four-digit 7-segment display counts up in milliseconds during the run and locks on the measured τ when the threshold is crossed. The result alternates with the percentage error against the 1000 ms theoretical value. A discharge mode times the inverse: from full charge down to 36.8 % of Vcc. Pre-conditioning logic automatically brings the capacitor to the correct starting voltage before each run, making every measurement repeatable. Green and red LEDs indicate charging and discharging phases; yellow lights on result. A three-note victory chime confirms each successful measurement.

What you get

  • Complete, commented source code
  • Full components list with quantities
  • Pin-by-pin wiring guide and connection table
  • Step-by-step upload and testing guide
  • Project report (.docx, IEEE style)
  • Presentation slides (.pptx)

More Electrical projects

ClampWatt Non-Invasive Appliance Energy Meter

Beginner₹109

CurrentForge — DC Motor Soft-Start Controller

Beginner₹109

JuncSentry — Diode Junction & Continuity Tester

Beginner₹109

OhmBridge — Wheatstone Bridge Resistance Analyzer

Beginner₹109

OscilloForge — NE555 Astable Frequency & Duty Cycle Analyzer

Beginner₹109

PhaseForge — 3-Phase AC Phasor Simulator

Beginner₹109